Materials and part workpieces

Top | Previous | Next

 

Woodwork for Inventor add-on uses its own materials which allow specifying assembly parts as components of wooden products. This enables automatic accumulation and presentation of material required to start the manufacturing process. This section will show you how to work with Woodwork for Inventor materials.

 

For more information on this topic, read the following sections:

 

Concept
Material group assignment command
Palette creation and control of their content

Creation of materials groups

Multilayer board assembler
Grain direction and oversize control
Material refresh

Designing composite parts
Edge body generator

Material and hardware replacement procedure - New method (v11)

Material and hardware replacement procedure - Old method