Configuration of displayed columns

Top | Previous | Next

 
The Woodwork for Inventor BOM generator allows the user to configure the display of the columns representing assembly data in the screen.

 

To open the command, go to:

 

W4I BOM –> ChooseColumns W4I_Bom_MainView_ChooseColumns

 

W4I BOM –> ChooseColumns  

A window will open displaying the following fields:

 

Code - corresponds to the Part Name field in the iProperties tab.
Name - corresponds to the Description field in the iProperties tab.
Path - file path.
Bom structure - defines the component type.
Quantity - the value of this field depends on the context in which a datum is displayed. If it is a/an:
Assembly - quantity is displayed in units.
Part - quantity is displayed in units.
Workpiece - quantity is displayed in units
Material - depending on the material type, a quantity in which the material is estimated can be displayed: length, width, volume.
 

Depending on what is displayed in a row (a part, a workpiece, or a material), the data in the nodes are displayed defining their following parameters:

Length
Width
Thickness

 

The following can be additionally displayed about a material:

Appearance Code
Appearance Name
Covering Side

 

The enabling/disabling of these fields is performed by checking appropriate boxes. The sequential order of the columns in the screen can be changed by Move Up, Move Down buttons.