This command is used to generate the dimensions of holes, their markings and a hole table in a drawing created by the user.
The command is accessible
Woodwork Design –> Holes -> Auto Plot Setup 
Select Base View |
A base projection is selected in which the coordinate dimensions of the holes will be placed. |
Select Additional Views |
If available, additional projections are selected. |
Ordinate Dimensioning |
Ordinate method of dimensioning is set. |
Chain Dimensioning |
Dimensioning in a chain is set. |
Mark Hole Centers |
Indicating that the centers of the holes should be marked. |
Mark Upside Down Hole Centers |
If the projection shows hidden lines, you can order that the reverse holes are also marked with the centre mark. |
Place Hole Tables |
Automatically generates and marks hole tables. |
Important!
All dimensions, hole marking and table output are based on AutoPlot settings, which have to be copied from the desired AutoPlot template. To do this, you need to run the AutoPlot settings command 
and via Copy AutoPlot settings specify the template file from which to copy the print settings.