Accessed via the menu: Components output to drawing -> Part -> Holes -> Hole dimensioning
This section allows you to order the automatic dimensioning of holes in your drawing. This is also where the dimension placement parameters are configured.
The dimensioning configuration has the following options.
Separate dimensioning for Vertical and other direction holes
|
The dimensions of holes drilled vertically into the projection are led to one side of the projection, while the dimensions of holes drilled in other directions are led to the other side.
 
|
Place dimensions in all views
|
Defines how dimensioning is performed in case more than one projection of the part is ordered and the dimensions of the holes are mapped in several projections. The projection used to lead the dimension is chosen according to the orientation of the hole in the projection. The priority of dimensioning is given to the projection in which the back of hole is facing the viewer.
|
Choice of Dimensioning style
|
Choosing the dimension style in which the dimensioning will be automatically performed.
|
Placing Scheme
|
The layout of the dimensions is selected in the panel.
|
Ordinate dimensioning Setup
|
Allows to set parameters for ordinate dimensioning.
|
|
Separate dimensioning for Vertical and other direction holes
|
Just like with ordinate dimensions, the dimensions of holes drilled vertically into the projection are led to one side of the projection, while the dimensions of holes drilled in other directions are led to the other side.
|
Place dimensions in all views
|
Defines how dimensioning is performed in case more than one projection of the part is ordered and the dimensions of the holes are mapped in several projections. The projection used to lead the dimension is chosen according to the orientation of the hole in the projection. The priority of dimensioning is given to the projection in which the back of hole is facing the viewer.
|
Choice of Dimensioning style
|
Choosing the dimension style in which the dimensioning will be automatically performed.
|
Placing Scheme
|
The layout of the dimensions is selected in the panel.
|
Chain dimensioning Setup
|
Allows to set parameters for dimensioning in a chain.
|
|
