Creating a CNC program for an item

Top | Previous | Next


This section describes how to create a set of programs for a CNC machine. Working through this manual will be more efficient and beneficial if you use a real item sample which can be downloaded by clicking the link below:


To properly open the downloaded item sample, the following conditions must be met:


1.Standard component libraries of the Woodwork for Inventor add-on which are installed as part of the standard add-on installation must be activated in the Autodesk Inventor project.


2.Woodwork for Inventor add-on must have a functional CAM module.


Let us assume that the program being created is intended for the machine programmed with Woodwop 6.0 software and is aimed at Weeke machines.